Availability: | |
---|---|
Quantity: | |
CNMC-D
CNMC
The instructions for operating a polyurethane injection machine may vary depending on the specific model and manufacturer. However, here are some general steps that are commonly involved in using a polyurethane injection machine:
Safety Precautions: Before operating the machine, make sure to wear appropriate personal protective equipment (PPE), such as gloves, goggles, and a respirator, to protect yourself from any potential hazards.
Preparation: Ensure that the polyurethane material and any required additives are properly mixed and ready for injection. Check that the machine is clean and in good working condition.
Set-Up: Connect the necessary hoses and fittings to the injection machine according to the manufacturer's guidelines. Make sure all connections are secure to prevent leaks during operation.
Adjust Settings: Set the desired injection pressure, temperature, and flow rate on the machine based on the manufacturer's recommendations and the requirements of your specific application.
Injection Process: Position the injection nozzle at the designated injection site and start the machine to begin injecting the polyurethane material. Monitor the injection process to ensure proper flow and coverage.
Cleanup: After completing the injection process, flush out the machine and hoses with a cleaning solution recommended by the manufacturer to prevent clogs and ensure proper maintenance.
Shutdown: Turn off the machine, disconnect hoses, and clean any leftover polyurethane material from the equipment to prevent hardening and damage.
Please note that these are general guidelines and it is important to follow the specific instructions provided by the manufacturer of your polyurethane injection machine for safe and efficient operation. If you have a particular model in mind or encounter any specific issues, feel free to provide more details for further assistance.
Power source:230v/110v single phase,50/60HZ
Whole power:7.5KW
Heater power:3kw each side
Driven mode:Pneumatic
Air source:more than 0.9cub meter/min,8bar
Chemical output:2-12kg/min
Maximum output pressure:13.8MPa
A and B chemical output ratio:1:1
Max hose support :15 meters
Machine size :800*700*1150mm
Weight:200kg
content is empty!